HPF XTR2, Руководство пользователя

Страница: 8 / 17

Cross Trainer XTR2
6
Electronic Monitor
10. Attach the electronic monitor (#50) to the main
frame bracket. Connect the monitor to the
sensor wire. See Fig.5.
With the press of a button, you can set the
electronic monitor of your XTR2 to display the
following information:
TIME : How long you have been exercising.
SPEED : How fast you are running.
DISTANCE : How far you would have run with
your two feet on the ground.
CALORIE : How many calories you have
burned.
Exercise Computer
FUNCTIONS:
•
SCAN : Automatically scans each function in sequence.
•
TIME : Counts the time duration of exercise from zero up to 99:59 in one second increment.
•
CALORIES : Accumulates the calorie consumption during exercise. This is a rough guide only and should be
used as a comparison over several exercise sessions.
•
DST : Accumulates the distance during workout session.
•
SPD : Displays the current speed.
KEY:
MODE/RESET (OPTION) : Press to select each function and hold the button for 3 seconds to clear all values,
NOTE:
•
Power-on automatically when start operating.
•
With no signal transmitted to the computer for 2 minutes, the computer will shut off the LCD display and
clear all measured value automatically.
•
The SCAN mode lets your monitor automatically alternate all of the four readouts in short intervals, so you
don’t have to stop and press a button to check for different information.
•
The monitor comes with 1×L1154 battery and tums itself off when not in use to conserve energy.
•
Replace batteries about every four months, depending on frequency of use.