HPE ProLiant m710x, Руководство пользователя и по обслуживанию

Страница: 17 / 58

• Single node:
set node power on C<x>N<y>
• Multiple nodes (4):
set node power on C<x>N1-4
• For all cartridges:
set node power on all
4. Verify that the power is on by issuing the following command:
show node power {CxNy}
Power up a cartridge locally
Procedure
1. Press and release the cartridge power button.
This method powers on all nodes.
2. Verify that the power is on by reviewing the status of the cartridge power LED.
For more information, see Cartridge LEDs and buttons on page 6.
Log in to the iLO CM firmware
Procedure
1. Connect to the iLO CM firmware locally or remotely:
To access the iLO CM firmware through the GUI, you must know the serial number or IP address of
the iLO CM. The serial number can be found on the chassis hood label.
• To connect remotely, use a browser or SSH session over the network.
• To connect locally, use a serial cable to connect a PC or terminal to the iLO CM management serial
port on the Moonshot 1500 CM module.
2. If no changes were made, enter the user name and password assigned for the chassis or the default
user name and password:
Default username:
Administrator
Default password:
password
For more information about the iLO CM firmware, see the HPE Moonshot iLO Chassis Management CLI
User Guide in the Hewlett Packard Enterprise Information Library ( http://www.hpe.com/info/moonshot/
docs ).
Power up a cartridge locally 17