HPE FlexFabric 5940 SERIES, Руководство по настройке безопасности

Страница: 402 / 571

389
g. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username.
After entering the username (
client002 ), you can enter the CLI of the server.
Password authentication enabled Stelnet client configuration
example
Network requirements
As shown in Figure 108 :
•
Switch B acts as the Stelnet server and uses password authentication.
•
The username and password of the client are saved on Switch B.
Establish an Stelnet connection between Switch A and Switch B, so you can log in to Switch B to
configure and manage Switch B.
Figure 108 Network diagram
Configuration procedure
1. Configure the Stelnet server:
# Generate RSA key pairs.
<SwitchB> system-view
[SwitchB] public-key local create rsa
The range of public key modulus is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
........................++++++
...................++++++
..++++++++
............++++++++
Create the key pair successfully.
# Generate a DSA key pair.
[SwitchB] public-key local create dsa
The range of public key modulus is (512 ~ 2048).
If the key modulus is greater than 512, it will take a few minutes.
Press CTRL+C to abort.
Input the modulus length [default = 1024]:
Generating Keys...
.++++++++++++++++++++++++++++++++++++++++++++++++++*
........+......+.....+......................................+
...+.................+..........+...+
Create the key pair successfully.