HPA HELPER ALLY 30, Руководство оператора

Страница: 6 / 14

22 Operator's manual
HELPER ALLY 30
N.B.: To fasten the bracket B fig. 4.4 to the
casing, remove the side panel of the tyre
changer, insert the locking nuts from the inside.
A
4.3
B
E
C
A
D
4.4
D
A
6. Position the HELPER and fasten it using the
screws
D (see fig. 4.3 and 4.4) without fully
tightening them.
4.1
3. Remove the hole protection caps.
4. Loosen the dowels G Fig. 4.2.
4.2
G
5. Fix the plate B to the casing using the screws
A (see fig. 4.3 and 4.4)
NOTE: If there is not an upper fixing hole
in the casing as shown in fig. 4.4, it must be
made on site using the support plate itself as
a template.
Proceed as follows:
- position the plate on the casing and fix it by
inserting the screw in the lower section.
- using a hand drill with ø 11 iron bit, drill in
correspondence of the upper hole.