7.
Lift the top cover from the chassis as shown in the following figure.
Figure 3
Removing the top cover
8.
Reinstall the side access panel.
Step 2—Installing rails and flanges
1.
Align the flange with the screw holes on the left side of the chassis (the bottom of chassis becomes
the left side for mounting) (1).
2.
Attach the flange (2), using a T-15 Torx screwdriver and two M4 screws.
3.
Align the inner slide with the two screw holes on the left side (the bottom) of the chassis (3).
NOTE:
The front inner slide is stamped “FRONT.”
4.
Attach the slide (4) using a T-15 Torx screw driver and two M4 screws.
5.
Repeat steps 1–4 for the right side (the top) of the chassis.
Figure 4
Installing rails and flanges
ENWW
Step 2—Installing rails and flanges
5
