Table 2-1
Computer Setup (F10) Utility menu descriptions (continued)
Heading
Option
Description
Advanced
2
Power-On
Options
Enables you to set the following:
●
POST Messages—Enables or disables the splash screen during POST.
●
Press the ESC key for Startup Menu
●
Option ROM
1
prompt (Enable or Disable)—Enabling this feature causes the workstation to
display a message before loading options ROMs.
●
After Power Loss (On, Off, Last State)—Enabling this option directs the previous state to be
the default.
●
POST Delay (in seconds) (5, 10, 15, 20, None)—Adds a specified delay to the POST
process. This delay is sometimes needed for hard disk drives on some expansion cards that
spin up slowly (so slowly that they are not ready to start by the time POST is finished). The
POST delay also gives you time to select F10 to enter Computer Setup (F10) Utility.
●
Remote Wakeup Boot Source—Enables you to set the remote wakeup boot source as:
◦
Local Hard Drive
◦
Remote Server
●
System Recovery Boot Support—(Disabled/Enabled)
●
Bypass F1 Prompt on Configuration Changes
BIOS Power-On
Enables you to disable or specify a weekday and time for BIOS power-on.
Bus Options
Configures graphics cards per workstation slots. In multi-graphics card configurations, this option
designates one card as primary graphics, and the other card as secondary graphics.
●
PCI SERR# Generation (Enabled/Disabled)—Controls PCI SERR# generation for ill-behaved
PCI add-in cards (that can generate SERR# spuriously)
●
PCI VGA Palette Snoop (Disabled/Enabled)—Controls PCI VGA Palette Snooping for
compatibility purposes
●
PCI Latency Timer—(32/64/128/160/192/224/248). 128 PCI Clocks is the default.
Onboard
Devices
Enables you to set resources (IRQ, DMA, I/O Rate) for or disable onboard system devices such as
serial port and diskette controller. Operating system parameters generally override Onboard
Devices settings.
Device Options
Enables you to set the following device options:
●
Num Lock State at Power-On (On or Off)
●
Internal speaker—(Enable or Disable)
●
NIC Option ROM
1
Download (Enable or Disable)
●
SATA RAID Option ROM
1
Download (Enable or Disable)
●
Multi-processor (Activates a single core.)—(Enable or Disable)
●
Hyper-Threading—(Enable or Disable)
●
CECP Mode—(Enable or Disable)
Computer Setup (F10) Utility
21
Содержание Z1
Страница 1: ...HP Z1 Workstation Maintenance and Service Guide ...
Страница 4: ...iv About this guide ...