Dual-state power button
With ACPI enabled, the power button can function as an on/off switch or as a sleep state button. This
feature does not completely turn off power, but instead causes the workstation to enter a low-power
standby state. This enables you to go to standby without closing applications, and to return to the same
operational state without any data loss.
Changing the power button configuration
To change the power button configuration:
1.
Select
Start
, and then select
Control Panel>Power Options
.
2.
In Power Options Properties, select the
Advanced
tab.
3.
In the Power Button section, select
Hibernate
.
NOTE:
Hibernate must be enabled in the Hibernate tab.
After configuring the power button to function as a sleep state button, you can press the power button
to put the workstation in a very low power state. Press the button again to bring the workstation out of
this low power state to full power state. To completely turn off power to the workstation, press and hold
the power button for four seconds.
CAUTION:
Do not use the power button to power off the workstation unless the system is not
responding; turning off the power without operating system interaction can cause data loss.
64
Chapter 4 System management
ENWW
Содержание Workstation Z800
Страница 1: ...HP Z800 Workstation Maintenance and Service Guide ...
Страница 4: ...iv About this guide ENWW ...
