Table 6-8
Diagnostic lights and audible codes (continued)
Activity
Possible cause
Recommended action
Red Power LED blinks four
times, once every second,
followed by a two-second
pause. Four beeps.
Power failure (power supply
is overloaded)
CAUTION:
Internal components might be powered even when the
workstation is off. To prevent damage, disconnect the workstation power
cord before you remove a component.
1.
Open the access panel and ensure that all power connections (18-
pin Main, 10-pin Memory, 8-pin CPU, 6-pin Aux. graphics, 4-pin
HDD bay) are secure on the system board:
2.
Check if a device is causing the problem by removing
all
attached
devices (such as hard, diskette, or optical disk drives, and
expansion cards.) Power on the workstation. If the workstation
enters the POST, power off and replace one device at a time;
repeat this procedure until failure occurs. Replace the device that is
causing the failure. Continue adding devices one at a time to
ensure all devices are functioning properly.
3.
Check the power supply functionality.
a. Disconnect the AC power.
b. Remove power supply from system chassis. (See
Removing the power
supply on page 86
for details.)
c. Plug in the AC power.
If the power supply fan spins and the BIST
**
LED lights, the power supply
is functional. The problem might be on the system board. Contact HP for
assistance.
If the power supply fan does not spin or the BIST
**
LED does not light, the
problem might be in the power supply. Contact HP for assistance.
Red Power LED blinks five
times, once every second,
followed by a two-second
pause. Five beeps.
Pre-video memory error
CAUTION:
Internal components might be powered even when the
workstation is off. To prevent damage, disconnect the workstation power
cord before you remove a component.
1.
Reseat DIMMs.
2.
Replace DIMMs one at a time to isolate faulty module.
3.
Replace third-party memory with HP memory.
4.
The problem might be on the system board. Contact HP for
assistance.
Red Power LED blinks six
times, once every second,
followed by a two-second
pause. Six beeps.
Pre-video graphics error.
CAUTION:
Internal components might be powered even when the
workstation is off. To prevent damage, disconnect the workstation power
cord before you remove a component.
1.
Reseat the graphics card.
2.
The problem might be on the graphics card. Contact HP for
assistance.
Red Power LED blinks seven
times, once every second,
followed by a two- second
pause. Seven beeps.
System board failure (ROM
detected failure prior to
video).
1.
Clear CMOS.
NOTE:
Refer to the
Maintenance and Service Guide
for the
workstation model for detailed information on clearing CMOS.
2.
The problem might be on the system board. Contact HP for
assistance.
246
Chapter 6 Diagnostics and troubleshooting
ENWW
Содержание Workstation Z800
Страница 1: ...HP Z800 Workstation Maintenance and Service Guide ...
Страница 4: ...iv About this guide ENWW ...
