HP StorageWorks 7110 - Virtual Array, Руководство по обслуживанию, Страница: 110 / 164

110 Servicing & Upgrading
If a DIMM failure did not occur:
a Remove the battery from the removed array controller. See "Removing
an Array Controller Battery" on page 117 .
b Remove the DIMMs from the removed array controller. See "Removing
an Array Controller DIMM" on page 120 .
Installing an Array Controller
(HP Service Personnel Only)
Caution If the green BATTERY LED is flashing and you remove a DIMM,
damage to the array controller or DIMM may occur.
Do not use a controller that has HP14 firmware as a replacement
if the remaining controller has an earlier version of firmware.
Earlier versions of firmware cannot overwrite HP14 firmware.
Replacement controllers ordered from HP have HP13 or earlier
firmware on them. If you are unsure of the firmware version on
the controller, do not use it as a replacement.
1 If the green BATTERY LED on the new or upgrade array controller is off, go
to step 2. If the green BATTERY LED on the new or upgrade array controller
is flashing with a 5% duty cycle (battery fully charged), disconnect the
battery from the battery terminal. See "Removing an Array Controller
Battery" on page 117 . Reconnect it and verify that the green BATTERY LED
is off.
Note Disconnecting the battery from the array controller resets a bit
on the controller which disables battery power to the DIMMs.
2 Either install new DIMMs (ordered separately) on the new array controller
or transfer functional DIMMs from the old controller. See "Installing an
Array Controller DIMM" on page 120 .
3 VA 7100 only : Slide the latch ( Figure 43 , 1) all the way to the left.
4 VA 7100 : Press down the lock ( Figure 43 , 2) and pull out the cam lever (3).
VA 7110/7400/7410 : Pull out the cam lever ( Figure 44 , 2).
5 Grasp the edges of the array controller with both hands and push it firmly
into the slot. ( Figure 43 or Figure 44 ).
6 Push in the cam lever ( Figure 43 , 3 or Figure 44 , 2) until it clicks into place.
7 VA 7100 only : Slide the latch ( Figure 43 , 1) all the way to the right.