HP StorageWorks 2500, Руководство пользователя

Страница: 31 / 91

1
2
Figure 17 Removing the EMU
Removing the I/O modules
To remove an I/O module:
1. Grasp the I/O module handle ( Figure 18 -1), press down on the module latch ( Figure 18 -2) and pull
the I/O module straight out of the enclosure ( Figure 18 -3). Take care not to tilt the module or bring it
in contact with the sides of the rack or other components.
2. Place the I/O module on an antistatic surface.
Figure 18 Removing an I/O module
Installing the DS2500 in the rack
WARNING!
A DS2500 without components installed weighs approximately 11.0 kg (24 lb). Even though a single
person can lift this weight, the DS2500 is dif fi cult to install because of its physical size. Therefore, HP
recommends that a minimum of two people install an empty DS2500 in a rack.
To install a DS2500:
1. From the front of the rack, slide the DS2500 onto the rails.
2. Secure the DS2500 to the front of the rack by tightening the four thumbscrews ( Figure 19 ).
HP StorageWorks 2500 Disk System user guide
31