HP ProLiant WS460c Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 51 / 102

Removal and replacement procedures 51
Heatsink blank
To remove the component:
1.
Power down the graphics server blade (on page 25 ).
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
2.
Place the graphics server blade on a flat, level work surface.
3.
Remove the access panel (" Access panel (graphics server blade) " on page 31 ).
4.
Do one of the following:
o
Remove the storage controller (" Storage controller " on page 50 )
o
Disconnect the direct connect SATA cable (" Direct connect SATA cabling " on page 80 ).
5.
Using a no. 2 Phillips screwdriver, remove the heatsink blank.
Retain the heatsink blank for future use.
To replace the component, reverse the removal procedure.
CAUTION: To avoid damage to the system board, processor socket, and screws, do not
overtighten the heatsink screws.
DIMM baffles
To remove the component:
The server contains two DIMM baffle.
1.
Power down the graphics server blade (on page 25 ).
2.
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
3.
Place the graphics server blade on a flat, level work surface.
4.
Remove the access panel (" Access panel (graphics server blade) " on page 31 ).
5.
Disconnect the direct connect SATA cable, if installed (" Direct connect SATA cabling " on page 80 ).
6.
Remove the internal USB drive, if installed. To locate the internal USB connector, see "System
board components (on page 91 )."