HP ProLiant WS460c Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 43 / 102

Removal and replacement procedures 43
10.
Disconnect all cables from the card and remove the graphics card from the expansion blade PCIe
card cage.
To replace the component, reverse the removal procedure.
Removing the NVIDIA Grid K1 and K2 I/O Plate
To remove the component:
1.
Power down the graphics server blade (on page 25 ).
2.
Remove the graphics server blade (" Remove the graphics blade " on page 26 ).
3.
Place the graphics server blade on a flat, level work surface.
4.
Remove the expansion blade access panel (" Expansion blade access panel " on page 31 ).
5.
Remove the expansion blade front bezel (" Remove the expansion module front bezel " on page
29 ).
6.
Remove the foam gasket (on page 27 ).
7.
Disconnect the power cable from the expander power board and the PCI graphics option.
8.
Remove the graphics expansion control cable.
9.
Remove the retaining block (on page 29 ).
10.
Remove the expansion blade PCIe card cage (on page 28 ).
11.
Remove the graphics card from the card cage.
IMPORTANT: For NVIDIA GRID K1 installation: Remove the pre-installed I/O plate from the
NVIDIA GRID K1 card and replace it with the I/O plate from the original NVIDIA GRID K1
card.
IMPORTANT:
Remove the I/O plate from the original NVIDIA GRID K2 card. Before
installing the NVIDIA GRID K2 I/O plate on the graphics expansion blade, the GRID K2 card
I/O plate must be assembled with the new spare part.