HP ProLiant ML310e Gen, Руководство по техническому обслуживанию и ремонту, Страница: 27 / 92

Removal and replacement procedures 27
To power down the server, use one of the following methods:
•
Press and release the Power On/Standby button.
This method initiates a controlled shutdown of applications and the OS before the server enters standby
mode.
•
Press and hold the Power On/Standby button for more than 4 seconds to force the server to enter
standby mode.
This method forces the server to enter standby mode without properly exiting applications and the OS.
If an application stops responding, you can use this method to force a shutdown.
•
Use a virtual power button selection through iLO.
This method initiates a controlled remote shutdown of applications and the OS before the server enters
standby mode.
Before proceeding, verify the server is in standby mode by observing that the system power LED is amber.
Drive blank or carrier
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1.
Unlock and open the tower bezel.
2.
Do one of the following:
o
In a non-hot-plug drive configuration, remove the drive carrier.
To replace the drive carrier, slide the component into the bay until it clicks.