HP ProLiant ML100 Series, Руководство пользователя

Страница: 57 / 103

7.
Check the UPS LEDs to be sure a battery or site wiring problem has not occurred. See the UP
documentation.
S
9.
was not caused by excessive heat, particularly if a recent air
mperature for UPS batteries is 25°C (77°F). For approximately
8.
If the UPS sleep mode is initiated, disable sleep mode for proper operation. The UPS sleep mode
can be turned off through the configuration mode on the front panel.
Change the battery to be sure damage
conditioning outage has occurred.
NOTE: The optimal operating te
every 8°C to 10°C (16°F to 18°F) average increase in ambient temperature above the optimal
temperature, battery life is reduced by 50 percent.
Actio
hours to charge the batteries, and then test
priately by changing the amount of time given before a low battery
warning. Refer to the UPS documentation for instructions.
EDs on the UPS is red
n for instructions regarding the specific LED to determine the cause
General
Problems with new hardware
:
1.
R fer n
the s
2.
Refer to the release notes included with the hardware to be sure the problem is not caused by a last
we
Low battery warning is displayed
n :
1.
Plug the UPS into an AC grounded outlet for at least 24
the batteries. Replace the batteries if necessary.
2.
Be sure the alarm is set appro
One or more L
Action : Refer to the UPS documentatio
of the error.
hardware problems
Action
e to the server documentation to be sure the hardware being installed is a supported option o
erver. Remove unsupported hardware.
minute change to the hardware release. If no documentation is available, refer to the HP support
bsite ( http://www.hp.com/support ).
sure the new hardware is installed properly. Refer to the device, server, and operating syste
umentation to be su
3.
Be m
doc re all requirements are met.
o
o
rmination or without proper ID settings
ce to Primary/Secondary when the other device is set to CS
Connection of the data cable, but not the power cable, of a new device
5.
nections (on page 43 ) exist.
locations and are the correct lengths. For more
information, refer to the server documentation.
Common problems include:
Incomplete population of a memory bank
Installation of a processor without a corresponding PPM
o
Installation of a SCSI device without te
o
Setting of an IDE devi
o
4.
Be sure no memory, I/O, or interrupt conflicts exist.
Be sure no loose con
6.
Be sure all cables are connected to the correct
Troubleshooting 57