HP ProLiant DL60 Gen9, Руководство по техническому обслуживанию и ремонту, Страница: 53 / 113

Removal and replacement procedures 53
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 27 ).
o
Remove the server from the rack (on page 30 ).
4.
Remove the access panel (" Access panel " on page 37 ).
5.
Remove the screws, then remove the processor blank.
To replace the component, reverse the removal procedure.
Processor
The server supports single-processor and dual-processor operations.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION:
To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
CAUTION: To prevent possible server overheating, always populate processor socket 2 with
a processor and a heatsink or a processor socket cover and a processor blank.
IMPORTANT: Processor socket 1 must be populated at all times or the server does not
function.
In a multiprocessor configuration, to optimize system performance, Hewlett Packard Enterprise
recommends balancing the total capacity of the DIMMs across the processors.
To remove the component:
1.
Power down the server (on page 27 ).