HP ProLiant DL60 Gen9, Руководство по техническому обслуживанию и ремонту

Страница: 44 / 113

Removal and replacement procedures 44
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 27 ).
o
Remove the server from the rack (on page 30 ).
4.
Remove the access panel (" Access panel " on page 37 ).
5.
If installed, remove any expansion board that blocks access to the SSD module (" Expansion board "
on page 58 ).
6.
Remove the SSD module.
To replace the component, reverse the removal procedure.
Optical drive blank
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives, power
input modules, and the internal system components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any system installation. Improper grounding can cause
electrostatic discharge.
To remove the component:
1.
If installed, remove the security bezel (" Remove the security bezel (optional) " on page 26 ).
2.
Power down the server (on page 27 ).
3.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
4.
Do one of the following:
o
Extend the server from the rack (on page 27 ).
o
Remove the server from the rack (on page 30 ).
5.
Remove the access panel (" Access panel " on page 37 ).