HP ProLiant DL385p, Руководство по техническому обслуживанию и ремонту

Страница: 52 / 102

Removal and replacement procedures 52
Expansion slot blanks
WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
CAUTION:
For proper cooling, do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components,
minimize the amount of time the access panel is open.
To remove the component:
1.
Power down the server (on page 25 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Extend (" Extend the server from the rack " on page 26 ) or remove (" Remove the server from the rack "
on page 27 ) the server from the rack.
4.
Remove the access panel (" Access panel " on page 30 ).
5.
Disconnect any external cables that are connected to the expansion board.
6.
Disconnect any internal cables that are connected to the expansion board.
7.
Remove the PCIe riser cage (" Remove the secondary PCIe riser cage " on page 34 , " Remove the
primary PCIe riser cage " on page 33 ).
8.
Remove the expansion slot blank.
To replace the component, reverse the removal procedure.
Expansion boards
Half-length expansion board