Diagnostic tools and setup utilities 86
POST error indicators
When POST detects a system failure, it displays a POST error message.
POST errors message definition
Whenever a non-fatal error occurs during POST, an error message describing the problem appears
onscreen. These error messages are displayed in normal video (white text on black background), and
show the details of the error. The following is an example of a POST error message:
012 --- CMOS Date/Time not set
Table 12
lists the most common POST error messages with corresponding troubleshooting
recommendation. HP recommends that you correct the error, even if the server appears to boot
successfully.
Table 12
POST Error Messages
Error-Code
Error Message
Description / Corrective Action
000
Timer Error
Indicates an error while programming the count register of
channel 2 of the 8254 timer. This may indicate a problem
with system hardware. Requires repair of the system board.
003
CMOS Battery Low
CMOS Battery is low. This message usually indicates that the
CMOS battery needs to be replaced. It could also appear
when the users intentionally discharge the CMOS battery.
004
CMOS setting Wrong
CMOS settings are invalid. This error can be resolved by
using F9 to load optimal default in the Setup Utility.
005
CMOS checksum bad and
boot in a safe configuration,
please reboot again for
optimal default settings.
CMOS contents failed the Checksum check. Indicates that the
CMOS data has been changed by a program other than the
BIOS or that the CMOS is not retaining its data due to
malfunction. This error can be resolved by using F9 to load
optimal default in the Setup Utility.
008
Unlock keyboard
PS2 keyboard is locked. Users need to unlock the keyboard to
continue the BIOS POST.
012
CMOS Date/Time not Set
The CMOS Date and/or Time are invalid. This error can be
resolved by readjusting the system time in the Setup Utility.
048
Password check failed
Password is incorrect after retried a few times. Users might
need to reset the password. 048 for power on password.
04C Keyboard/Interface
Error
Keyboard controller failed test. This may indicate a problem
with system hardware.
04D
Primary Master Hard Disk
Error
The IDE/ATAPI device configured as Primary Master could not
be properly initialized by the BIOS.This message is typically
displayed when the BIOS is trying to detect and configure
IDE/ATAPI devices in POST
Содержание ProLiant DL160 G5P
