HP ProLiant DL160 G5P, Руководство по обслуживанию

Страница: 69 / 95

Removal and replacement procedures 69
System battery
The server uses nonvolatile memory that requires a battery to retain system information when power is
removed.
This 3-volt lithium coin cell battery is located on the system board.
Figure 54 System battery location
WARNING: Note the following reminders when replacing the system battery:
•
Replace the battery with the same type as the battery recommended by HP. Use of another
battery may present a risk of fire or explosion.
• A risk of fire and chemical burn exists if the battery is not handled properly. Do not disassemble,
crush, puncture, or short external contacts, or expose the battery to temperatures higher than
60°C (140°F).
•
Do not dispose of used battery in water or fire. Dispose of used batteries according to
manufacturer's instructions.
CAUTION: Loss of BIOS settings occurs when the battery is removed. You must reconfigure BIOS
settings whenever you replace the battery.
NOTE: If the server no longer automatically displays the correct date and time, you may need to
replace the system battery. Under normal usage, battery life is five to ten years.
To replace the system battery:
1.
To release the battery from its holder, squeeze the metal clamp that extends above one edge of
the battery. When the battery pops up, lift it out.
2.
To insert the new battery, slide one edge of the replacement battery under the holder’s lip with
the positive side up. Push the other edge down until the clamp snaps over the other edge of the
battery.