HP ProCurve 8212zl Series, Руководство по установке и началу работы

Страница: 65 / 138

3-3
Getting Started With Switch Configuration
Get
tin
g S
ta
rte
d
With
S
w
itch
Co
nfi
gurati
o
n
3. Use the Tab key to select the Manager Password field and enter a manager
password of up to 16 characters.
4. Tab to the
IP Config (DHCP/Bootp)
field and use the Space bar to select the
Manual
option.
5. Tab to the IP Address field and enter the IP address that is compatible with
your network.
6. Tab to the
Subnet Mask
field and enter the subnet mask used for your
network.
7. Press Enter, then S (for Save ).
The following is information on the fields in the Setup screen. For more
information on these fields, see the
Management and Configuration Guide
which is on the ProCurve Web site. See page 5-1 for details.
Parameter Default
System Name blank Optional; up to 255 characters, including spaces
System Contact blank Optional; up to 255 characters, including spaces
Manager Password blank Recommended; up to 16 characters (no blank spaces)
Logon Default CLI The default setting selects the command line interface for console access.
The alternative is the Menu interface.
Time Zone 0 (none) Optional; 1440 to -1440. The number of minutes your location is to the
West (-) or East (+) of GMT.
Community Name public Default setting recommended.
Spanning Tree Enabled No Default setting recommended unless STP is already running on your network
or the switch will be used in complex network topologies.
Default Gateway blank Recommended; Enter the IP address of the next-hop gateway node if network
traffic needs to be able to reach off-subnet destinations.
Time Sync Method TimeP Optional; The protocol the switch uses to acquire a time signal. The options
are SNTP and TimeP.
TimeP Mode Disabled Synchronizes the time kept on the switch to the TimeP server.
IP Config DHCP/Bootp Set to Manual unless a DHCP/Bootp server is used on your network to
configure IP addressing.
IP Address xxx.xxx.xxx.xxx Recommended; If you set IP Config to Manual, then enter an IP address
compatible with your network.
Note: The IP address and subnet mask assigned for the switch must be compatible with the IP addressing used in your
network. For more information on IP addressing, see the Management and Configuration Guide which is on the ProCurve
Web site. See page 5-1 for details.
Subnet Mask xxx.xxx.xxx.xxx Recommended; If you entered an IP address, then enter a subnet mask
compatible with your network.