HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 62 / 134

Getting Started With Switch Configuration
Setting Basic System Information
Get
ting
S
ta
rte
d W
ith
S
w
it
ch
Co
nfi
gurati
o
n
Setting Basic System Information
The first, and only essential, task in basic system configuration is assigning a
Management IP address to the switch. This is the IP address that you use to
access the ProCurve Switch 8100fl on the network. You must enable the
management port and you must enable telnet in order to access the switch
remotely.
Follow the procedures in this section to set the following system information:
■ IP address for the management port on the management module
■
System time and date
■ System name
■
System location
■ Contact name (the person to contact regarding this switch)
■
Log in banners
N o t e s
This section assumes a basic understanding of CLI commands, modes, and
procedures. For more detailed information, refer to the
Management and
Configuration Guide on the Documentation CD-ROM that comes with your
switch.
The running configuration remains in effect only during the current power
cycle. If you power off or reboot the switch without saving the running
configuration changes to the Startup configuration file, the changes are lost.
For details on savings your configuration, refer to
“Saving and Using the New
Configuration” on page 3-4 .
Setting the Management Module IP Address
To set the system IP address and enable Telnet access to the switch:
1. From the Exec (>) prompt, enter the
enable
command to get to the
Privileged Exec mode in the CLI.
2. From Privileged Exec mode, enter the
configure
command to get to
Configuration mode.
3. From Configuration mode, enter the following command:
Switch 8100fl(config)#interface management0
3-2