HP ProCurve 8116fl, Руководство по установке и началу работы

Страница: 34 / 134

Installing the ProCurve Switch 8100fl
Installation Procedures
Module Port Type/
Transceiver Cable Type Length Limits
1-Port 10-GbE 10-Gbe LR 9/125
μ
m (core-cladding) diameter, 1310 nm, 10 kilometers
Interface Module low metal content, single-mode fiber optic
(J8733A) cables fitted with SC connectors. The cables
must comply with the ITU-T G.651 and ISO/
IEC 793-2 Type A1b or A1a standards.
Inst
alli
ng t
he Pro
C
u
rve
Switch 8100fl
X2 10-GbE 10-GbE SR Multimode fiber-optic cable designed for
Modules Gigabit Ethernet: 62.5/125
μ
m (core/
(J8736A and
cladding) diameter or 50/125
μ
m, 850 nm, low
J8737A)
metal content, complying with the ITU-T
G.652 and ISO/IEC 793-2 Type B1 standards.
62.5
μ
m cable:
• 160 Mhz*km = 2-26 meters
• 200 Mhz*km = 2-33 meters
50
μ
m cable:
• 400 Mhz*km = 2-66 meters
• 500 Mhz*km = 2-82 meters
• 2000 Mhz*km = 2-300
meters
10-GbE LR 9/125
μ
m (core/cladding) diameter, 1480 nm, single-mode cable: 2-10
low metal content, single mode fiber-optic kilometers
cables, complying with the ITU-T G.652 and
ISO/IEC 793-2 Type B1 standards.
10-GbE ER 9/125
μ
m (core/cladding) diameter, 1550 nm, single-mode cable: 2-30
low metal content, single mode fiber-optic kilometers (40 kilometers, on
cables, complying with the ITU-T G.652 and an engineered fiber optic link
ISO/IEC 793-2 Type B1 standards. that meets standards in the
specification).
OMC CX4 Fiber 12 fiber 50/125
μ
m (core/cladding) diameter, 1-300 meters
(Optical Media multimode Fiber ribbon cable. 12 fiber 62.5/
Converter) for 125
μ
m (core/cladding) diameter, multimode
CX4 transceiver Fiber ribbon cable is also supported.
Note: Conditioning patch cord cables are not supported on 10-GbE speeds.
Installation Location
Before installing the switch, plan its location and orientation relative to other
devices and equipment:
■ In the front of the switch, allow at least 7.6 cm (3 inches) of space for the
twisted-pair and fiber-optic cabling.
■ In the back of the switch, allow at least 10.2 cm (4 inches) of space for the
power cable and cooling. Attach the power cable to the switch before you
install the switch. Then install the switch without power supplies. Next,
install the power supplies and connect the other end of the power cable
to the AC electrical outlet when you want to power on the switch.
■ On the sides of the switch, leave at least 7.6 cm (3 inches) for cooling.
2-8