Commands and Responses
HP NonStop TMF Management Programming Manual—540140-008
5-165
STATUS AUDITTRAIL
ZCommitHoldTime
This value is valid only when ZCommitHold is “activate” or “reviving.” The value
specifies the time at which the specified audit trail went into its current state.
ZCommitHoldVol
This value is valid only when ZCommitHold is “activate” or “reviving.” The value
specifies the name of the audit-trail volume that encountered the problem
causing the audit trail to go into this state.
ZCommitHoldTimeRem
If the specified audit trail's ZCommitHold state is either “activate” or “reviving,”
and the MAT's commit-hold mode has not been altered to “suspend,” the value
of this token is the time in seconds before the MAT's ON TIMEOUT action will
occur. If the MAT's TIMEOUT is -1, the value of this token is null.
ZTimeoutAction
The action that will occur when the ZCommitHoldTimeRem expires. This action
is the MAT's ON TIMEOUT action. The following values are possible:
Usage Guidelines
Any user can issue this command. TMF must be started.
Multiple response records are allowed to enable the command to return all the
requested information.
ZTMF-VAL-ZLTCH-ActionSuspend
Suspend the commit-hold
condition.
ZTMF-VAL-ZLTCH-ActionCrash
Crash TMF.
Содержание NonStop TMF
