Isolating Remote Snap replication faults
65
Can you create a replication set?
Answer Possible reasons
Actions
Yes
System functioning properly.
No action required.
No
Selected link type or port-to-link
connections are incorrect.
•
Remote Replication mode: In the Configuration View panel in
the SMU, right-click the remote system, and select
Tools
>
Check
Remote System Link
. Click
Check Links
to verify correct link type
and remote host port connections.
•
Local Replication mode: In the Configuration View panel in the
SMU, right-click the local system, and select
Tools
>
Check Local
System Link
. Click
Check Links
to verify correct link type and
local host port connections.
No
On controller enclosures with iSCSI
host interface ports, replication set
creation fails due to use of CHAP.
If using CHAP (Challenge-Handshake Authentication Protocol),
configure it as described in the SMU topics “Using the Replication
Setup Wizard” or “Replicating a volume.”
No
Unable to select the replication
mode (Local or Remote)?
•
In the SMU, review event logs for indicators of a specific fault in
a host or replication data path component. Follow any
Recommended Actions.
•
Local Replication mode replicates to a secondary volume
residing in the local storage system.
• Verify valid links.
On dual-controller systems, verify that A ports can access B
ports on the partner controller, and vice versa.
• Verify existence of either a replication-prepared volume of
the same size as the master volume, or a vdisk with sufficient
unused capacity.
•
Remote Replication mode replicates to a secondary volume
residing in an independent storage system:
• Verify selection of valid remote vdisk.
• Verify selection of valid remote volume on the vdisk.
• Verify valid IP address of remote system network port.
• Verify user name with Manage role on remote system.
• Verify user password on remote system.
NOTE:
If the remote system has not been added, it cannot
be selected.
No
Unable to select the secondary
volume (the destination volume on
the vdisk to which you will replicate
data from the primary volume)?
•
In the SMU, review event logs for indicators of a specific fault in
a replication data path component. Follow any Recommended
Actions.
•
Verify valid specification of the secondary volume according to
either of the following criteria:
• Creation of new volume on the vdisk
• Selection of replication-prepared volume
No
Communication link is down.
See actions described in
"Can you view information about remote
.
Table 17
Diagnostics for replication setup: Creating a replication set
Содержание MSA 2040
