HP Model 745 - VME Workstation, Руководство пользователя, Страница: 200 / 220

B-20
The Boot Console Interface
Displaying and Setting the Monitor Type
Using the Emergency Interactive Console Search
If the system console is set to a device that is not installed in the system, you
can use the emergency interactive console search to set the console to one of
the terminal devices that is currently connected.
Use the following procedure to set the console with the emergency interac-
tive console search:
1 Make sure that the monitor(s) and/or terminal(s) are powered on.
2 Hold the Model 745 board computer’s reset/abort switch in its Abort po-
sition, then turn on power to the chassis.
3 A message similar to the following is displayed on each monitor connect-
ed to a graphics device recognized by the system:
GRAPHICS(s) MONITOR INFORMATION
Slot Model Type Resolution Freq Class
---- ----------------- ---- ---------- ---- -----
0 INTERNAL_EG_1280 12 1280x1024 75Hz
The following keyboard(s) are available:
PS2
HIL
Press the <n> key to select GRAPHICS(s) as the CONSOLE or
press the <Tab> key to select the next monitor type.
Where n is a single-digit number or a keyboard key.
When the message is displayed clear and undistorted on the monitor for your
console device, enter the number or key that corresponds to the display device
that you are selecting.
NOTE:
The message is displayed for sixty seconds before proceeding to the next monitor
resolution.
If you are using a power saving monitor, the power LED will light when the monitor
senses a valid video synch signal
.
If this message is not displayed on your monitor, review the installation procedures
to make sure that you correctly installed the option board.