HP LaserJet 9040/9050 - Multifunction Printer, Руководство администратора

Страница: 31 / 56

Situation Possible Reason
The job went to a different output location than expected.
●
The paper does not meet the specifications for the output
bin. (See
Specifications on page 35 , or go to . )
●
Make sure that the correct output bin is selected in the
printer driver. For more information about changing
printer driver settings, see your printer user guide.
The print media jams. ● Make sure that you are using the supported media
weights and sizes. (See
Supported media
on page 39 .)
Using paper outside HP specifications might cause problems
that require repair. This repair is not covered by the Hewlett-
Packard warranty or service agreements.
● Check the cables and connectors between the printer and
the device.
●
Repeated jams that occur when print media travels
between the printer and the device might mean that the
printer and device are set up on an uneven floor. Level
the device. See the device installation guide for
instructions about leveling the device.
You are experiencing general repeated stapler jam
problems.
●
Check to see that the job to be stapled is less than 50
sheets thick.
● The stapler might have some trapped staple wires
obstructing the cartridge. Remove loose staples and
paper dust from the inside of the stapler. (See
Clear a
staple jam from the device on page 32 .)
You are experiencing general repeated booklet jam problems.
●
The paper does not meet the specifications for the booklet
bin. (See
Specifications on page 35 , or go to
www.hp.com/cposupport/ .)
● To improve the quality of booklets, HP recommends that
you use heavy media for the cover. If the booklets contain
more than five pages, HP recommends including a 5-mm
(0.19-inch) white margin at the seam.
●
If booklet jams continue, contact your local authorized HP
service provider. (See
Service and support
on page 45 .)
Table 3-1 Common device problems (continued)
ENWW Resolve common problems 25