4 Technical Information
The HP Summary Screen and Setup Program
88
English
The HP Summary Screen and
Setup
Program
This section introduces the HP Summary Screen and the HP
Setup
program. You can use the Summary Screen and the
Setup
program to
configure your PC Workstation and solve configuration problems with
your PC Workstation.
Viewing the HP Summary Screen
Check your PC Workstation’s configuration when you first use the PC
Workstation and each time after you install, remove, or upgrade
accessories. To check the configuration:
1
Turn on the display and then the PC Workstation. If the PC
Workstation is already turned on, save your data and exit all
programs, then restart the PC Workstation. Consult your operating
system documentation for any special instructions concerning
turning off and then restarting your PC Workstation.
2
While the start-up logo appears on your display, press
Esc
. This
takes you to the HP Summary Screen. (To go immediately into the
Setup
program, and bypass the Summary Screen, press
F2
instead of
Esc
). The Summary Screen is displayed for only a short time. To
retain the screen (until you decide to leave it), press
F5
.
Starting the HP
Setup
Program
1
Turn on the display and then the computer. If the PC Workstation is
already turned on, save your data and exit all programs, then restart
the PC Workstation. Consult your operating system documentation
for any special instructions concerning turning off and then
restarting your PC Workstation.
2
Press
F2
while
F2 Setup
is displayed at the bottom of the screen.
If you fail to press
F2
in time and the start-up process continues, you
will need to restart your PC Workstation to go through the POST
again so you can press
F2
.
3
The opening screen of the PC Workstation’s
Setup
program is
displayed. Note that the Main menu selection is highlighted.
ashaki.bk : ashak-4.fb4 Page 88 Thursday, September 10, 1998 5:58 PM
