464
Step Command
Remarks
enter auto-discovery VSI
view.
through BGP.
4.
Configure an RD for the
auto-discovery VSI.
route-distinguisher
route-distinguisher
By default, no RD is configured for
the auto-discovery VSI.
5.
Configure route targets for
the auto-discovery VSI.
vpn-target
vpn-target
&<1-8>
[
both
|
export-extcommunity
|
import-extcommunity
]
By default, no route targets are
configured for the auto-discovery
VSI.
6.
(Optional.) Reference a PW
class.
pw-class
class-name
By default, no PW class is
referenced.
7.
(Optional.) Reference a
tunnel policy.
tunnel-policy
tunnel-policy-name
By default, no tunnel policy is
referenced.
8.
Use BGP to create a PW to
an automatically discovered
remote PE and enter
auto-discovery VSI BGP
signaling view.
signaling-protocol
bgp
By default, no signaling protocol is
specified.
9.
Create a local site.
site
site-id
[
range
range-value
]
[
default-offset
default-offset
]
By default, no local site is created.
Configuring a BGP auto-discovery LDP PW
Before you perform this configuration, enable MPLS LDP on interfaces and globally. For more
information, see "
To configure a BGP auto-discovery LDP PW, perform the following configurations on PEs:
•
Configure BGP to advertise VPLS PE information.
•
Use LDP to create a PW.
Configuring BGP to advertise VPLS PE information
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enable BGP and enter BGP
view.
bgp
as-number
By default, BGP is disabled.
3.
Configure the remote PE as
a BGP peer.
peer
{
group-name
|
ip-address
[
mask-length
] }
as-number
as-number
By default, no BGP peer is
configured.
4.
Create the BGP L2VPN
address family and enter
BGP L2VPN address family
view.
address-family l2vpn
By default, the BGP L2VPN
address family is not created.
5.
Enable BGP to exchange
VPLS PE information with
the specified peer or peer
group.
peer
{
group-name
|
ip-address
[
mask-length
] }
enable
By default, BGP cannot exchange
VPLS PE information with a peer
or peer group.
6.
Enable BGP to exchange
VPLS PE information with
the specified peer or peer
group.
peer
{
group-name
|
ip-address
[
mask-length
] }
auto-discovery
[
non-standard
]
By default, BGP can exchange
VPLS PE information with a BGP
L2VPN peer or peer group by
using RFC 6074
MP_REACH_NLRI.
7.
(Optional.) Permit the local
AS number to appear in
peer
{
group-name
|
ip-address
[
mask-length
] }
allow-as-loop
By default, the local AS number is
not allowed in routes from a peer
Содержание HPE FlexNetwork MSR Router Series
Страница 10: ...viii Index 540 ...
