HP flexnetwork 5510 hi series, Руководство по установке

Страница: 41 / 82

36
Identifying physical IRF ports on the member switches
Identify the physical IRF ports on the member switches according to your topology and connection
scheme.
Table 9 shows the physical ports that can be used for IRF connection and the port use restrictions.
Table 9 Physical IRF port requirements
Candidate physical IRF ports Requirements
•
Four fixed SFP+ ports on the front panel
•
Ports on the interface card on the rear panel
•
All physical ports to be bound to an
IRF port must have the same data
rate.
•
If a QSFP+ port is split into four
SFP+ ports, the QSFP+ port cannot
be used as a physical IRF port.
Planning the cabling scheme
Use SFP+/QSFP+ DAC cables or SFP+/QSFP+ transceiver modules and fibers to connect the IRF
member switches. If the IRF member switches are far away from one another, choose the
SFP+/QSFP+ transceiver modules with optical fibers. If the IRF member switches are all in one
equipment room, choose SFP+/QSFP+ DAC cables. For more information about SFP+/QSFP+ DAC
cables and SFP+/QSFP+ transceiver modules, see "
Appendix C Ports and LEDs ."
The following subsections describe several HPE recommended IRF connection schemes, and all
these schemes use a ring topology.
IMPORTANT:
In these schemes, all physical IRF ports are located on the same side. If physical IRF ports are on
different sides, you must measure the distance between them to select an appropriate cable.
Connecting the IRF member switches in one rack
Use SFP+ DAC cables to connect the IRF member switches (9 switches in this example) in a rack as
shown in
Figure 41 . The switches in the ring topology (see Figure 42 ) are in the same order as
connected in the rack.