HP flexnetwork 5510 hi series, Руководство по установке

Страница: 29 / 82

24
2.
Plug the female connector end of the AC power cord into the AC input socket of the power
supply (see callout 1 in
Figure 30 ).
3.
Use a cable tie to secure the power cord to the handle of the power supply (see callout 2 and
callout 3 in
Figure 30 ).
4.
Connect the other end of the AC power cord to an AC power outlet.
Figure 30 Connecting a PSR720-56A (JG544A) power supply
Installing/removing an interface card
CAUTION:
•
Do not touch the surface-mounted components on an interface card directly with your hands.
•
Do not use excessive force during the installation or removal procedure.
•
Install a filler panel over an empty interface card slot.
The switch has an interface card slot and supports hot swapping of an interface card. For the
interface cards available for the switches, see "
Appendix B FRUs and compatibility matrixes ."
This section uses the LSWM2SP2PM interface card as an example to describe the procedures of
installing and removing an interface card.
Installing an interface card
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Remove the filler panel from the target interface card slot as follows:
a.
Remove the screw on the filler panel.
b.
Use a flathead screwdriver to remove the filler panel.
Keep the filler panel for future use.