4
Removal and replacement procedures
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to
, select your country or region, and then
follow the on-screen instructions.
Adherence to the procedures and precautions described in this chapter is essential for proper service. After
completing all necessary removal and replacement procedures, run the Diagnostics utility to verify that all
components operate properly.
NOTE:
Not all features listed in this guide are available on all computers.
Preparation for disassembly
See
Routine care, SATA drive guidelines, and disassembly preparation on page 14
for initial safety procedures.
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Shut down the computer properly through the operating system, then turn off any external devices.
3.
Disconnect the power cord from the power outlet.
CAUTION:
Regardless of the power-on state, voltage is always present on the system board as long as
the system is plugged into an active AC outlet. You must disconnect the power cord and wait
approximately 30 seconds for the power to drain to avoid damage to the internal components of the
computer.
4.
Disconnect all cables from the rear I/O connectors.
CAUTION:
The screws used in the computer are of different thread sizes and lengths; using the wrong screw
in an application may damage the unit.
NOTE:
During disassembly, label each cable as you remove it, noting its position and routing. Keep all
screws with the units removed.
Preparation for disassembly
19
Содержание Engage One Retail System 143
Страница 4: ...iv Safety warning notice ...
