HP EH920A - StorageWorks Ultrium 1760 Tape Drive, Руководство пользователя, Страница: 19 / 67

3 Installing an HP StorageWorks
Tape Blade
In this chapter:
•
“ Before you start ” on page 19
• “ Installation with a half-height partner server blade ” on page 20
• “ Installation with a full-height partner server blade ” on page 24
• “ Powering the tape blade on and off ” on page 28
Before you start
These installation instructions assume you have already:
1.
Installed and con fi gured an HP BladeSystem c-Class enclosure. It must be running the correct
fi rmware for it to support the tape blade. Firmware version 1.3 or later is required when installing in
a c7000 enclosure. In a c3000 enclosure all versions of the fi rmware support the HP StorageWorks
Tape Blade. For the best reliability, performance and new features update to the most recent version
of the fi rmware.
2.
Installed the partner server blade. It must be powered off before you install the tape blade. We
recommend that you use the Shutdown command on the partner server blade to do this.
3. Installed
any device bay dividers as recommended in the documentation provided with the c-Class
enclosure.
NOTE:
The most current documentation for HP BladeSystem components is available at the HP website
( http://www.hp.com/go/bladesystem/documentation
).
You need one half-height device bay in which to install the HP StorageWorks Ultrium Tape Blade. The
tape blade may be used with a half-height or a full-height server blade and must be installed next
to the partner server blade.
Tape Blade
19