HP E3494A, Инструкция по установке и обслуживанию

Страница: 28 / 108

To verify LAN communications
1
Verify your HP processor probe is now active and on the network by
issuing a
telnet to the IP address.
This connection will give you access to the HP processor probe’s built-in
terminal interface.
2
To view the LAN parameters, enter the lan command at the terminal
interface prompt.
3
To exit from this telnet session, type <CTRL>D at the prompt.
The best way to change the HP processor probe’s IP address, once it has
already been set, is to telnet to the HP processor probe and use the terminal
interface lan command to make the change. Remember, after making your
changes, you must cycle power or enter a terminal interface init -p command
before the changes take effect. Doing this will break the connection and end
the telnet session.
If You Have Problems
If you encounter problems, refer to the "Problems" chapter (page 75).
Example
$ telnet 192.35.12.6
R>lan
lan is enabled
lan -i 192.35.12.6
lan -g 192.34.12.1
lan -p 6470
Subnet Mask: 255.255.255.0
Ethernet Address: 08000F090B30
Connecting to the Host Computer
To verify LAN communications
20