HP E3491A, Инструкция по установке и обслуживанию

Страница: 58 / 70

To execute the built-in performance verification test
In addition to the powerup tests, there are six additional performance
verification tests available. These six testa are Powerup PV Results, LAN
10BASE2 Feedback Test, LAN 10BASET Feedback Test, Break In and
Trigger Out BNC Feedback Test, Target Probe Feedback Test, and Boundary
Scan Master Test.
Four of these tests can be invoked through the prototype analyzer. The LAN
tests can only be executed through the RS-232 port.
To perform the PV tests through the prototype analyzer:
1
Disconnect the target cable from the target system, and attach the
terminator to the end of the target system cable.
2 In the Sys Admin menu, select Start PV.
The results will appear on screen.
LAN Tests
The LAN tests can only be executed through the RS-232 port. The
remainder of this section assumes that the tests are being run from a terminal
emulator connected to the RS-232 port.
For the BREAK IN, TRIGGER OUT BNC FEEDBACK TEST, connect a
coaxial cable between BREAK IN and TRIGGER OUT
For the TARGET PROBE FEEDBACK TEST, replace target cable with
feedback connector E3490-61604
1
Set all of the switches to OPEN.
This is standard RS-232 at 9600 baud which can be connected directly to a 9
pin RS-232 interface that conforms to the IBM PC-AT 9 pin standard.
2
Use a terminal emulator to connect to the HP E3491A Pentium Probe.
3
Enter the pv command.
Options available for the "pv" are explained in the help screen displayed by
typing "help pv" or "? pv" at the prompt. The help screen output will appear
similar to the screen shown on the following page:
Solving Problems
To execute the built-in performance verification test
50