HP E3491A, Инструкция по установке и обслуживанию

Страница: 26 / 70

To configure LAN parameters using the built-in
terminal interface
This procedure should only be used if you have difficulty establishing LAN
communication via the HP 16505A Prototype Analyzer Run Control interface.
1
Set configuration switches S1 through S4 to CLOSED, and set the
other switches as appropriate for your serial interface.
Switch settings are printed on the bottom of the HP E3491A Pentium Probe.
If you will use a baud rate of 9600 baud, set the switches like this:
2
Connect an ASCII terminal (or terminal emulator) to the HP E3491A
Pentium Probe’s RS-232 port with a 9-pin RS-232 cable.
Complete instructions for setting up a serial connection begin on page 15.
3
Plug in the HP E3491A Pentium Probe’s power cord. Press the
terminal’s <RETURN> key a couple times. You should see a "p>" or
"R>" prompt.
At this point, you are communicating with the HP E3491A Pentium Probe’s
built-in terminal interface.
4
Display the current LAN configuration values by entering the lan
command:
R>lan
lan is disabled
lan -i 0.0.0.0
lan -g 0.0.0.0
lan -p 6470
Ethernet Address : 08000903212f
The "lan -i" line shows the current IP address (IP address) of the HP E3491A
Pentium Probe.
The Ethernet address, also known as the link level address, is preassigned at
the factory, and is printed on a label above the LAN connectors.
5
Enter the following command:
lan -i <internet> [-g <gateway>] [-p <port>]
Setting Up a Serial Connection
To configure LAN parameters using the built-in terminal interface
18