HP E-MSM310, Руководство по управлению и настройке

Страница: 127 / 210

Network configuration
IP routes
5-15
DNS switch over
This setting controls how the AP switches back to the primary DNS server after it has
switched to the secondary DNS server because the primary was unavailable.
 When enabled, the AP switches back to the primary server after it becomes available
again.
 When disabled, the AP switches back to the primary server only if the secondary server
becomes unavailable.
IP routes
All wireless traffic on the AP is bridged to the egress interface on the VSC with which it is
associated. Therefore, IP routes cannot be applied to user traffic. However, IP routes can be
used to ensure that the management traffic generated by the AP is sent to the correct
destination. For example, if two VSCs are defined, each with authentication assigned to a
different RADIUS server operating on a different subnet and VLAN, routing table entries may
be required to ensure proper communication with the RADIUS servers.
Configuration
To view and configure IP routes, select Network > IP routes .
Active routes
This table shows all active routes on the AP. You can add routes by specifying the appropriate
parameters and then selecting Add.
The routing table is dynamic and is updated as needed. This means that during normal
operation the AP adds routes to the table as required. You cannot delete these system routes.
The following information is shown for each active route:
 Interface : The port through which traffic is routed. When you add a route, the AP
automatically determines the interface to be used based on the Gateway address.
 Destination : Traffic addressed to this IP address is routed.
 Mask : Number of bits in the destination address that are checked for a match.