Installing Hardware Options
Refer to
www.compaq.com/quickspecs
for DIMM option kits.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you
are properly grounded before beginning any installation procedure. Refer to
Appendix B, “Electrostatic Discharge,” for more information.
To install a DIMM onto the system board:
1.
Access internal server components. Refer to the “Accessing Internal Server
Components” section earlier in this chapter.
2.
Open the DIMM socket latches.
3.
Align the key slot in the bottom edge of the DIMM with the tab in the expansion
socket.
IMPORTANT:
Misaligned DIMMs do not seat.
4.
Press down firmly on the DIMM while pushing the latches inward until the
latches snap into place.
5.
Reverse the procedures performed in the “Accessing Internal Server
Components” section earlier in this chapter.
Installing an Expansion Board
To install an expansion board, complete the procedures described in the following
subsections.
3-8
HP ProLiant DL320 Generation 2 Server Setup and Installation Guide
HP CONFIDENTIAL
Writer: Anna Roberts File Name: d-ch3 Installing Hardware Options.doc
Codename: MoonStar Part Number: 293166-002 Last Saved On: 1/31/03 11:16 AM
