HP D5970A - NetServer - LCII, Руководство по установке

Страница: 102 / 203

Chapter 8 Rack Mounting the HP NetServer
94
5. Attach rack nuts to the outside face of the other front rack column.
See Steps 2 through 4.
6. Turn the template over and use it to mount rack nuts on the left-rear and
right-rear rack columns.
The template provides you with the nut placement locations. If you don’t
have the template, Figure 8-4 shows rack nut placement for the two rear
rack columns.
Bottom of
Server
Attach nuts to this face
of the rear columns
Left
Right
Rear of
Rack
#
#
#
#
#
Fourth Hole
From Bottom
Sixth Hole
From Bottom
"#" represents
the EIA unit
numbers on the
rack
#
columns
Figure 8-4. Rack Nut Locations on the Rack’s Rear Columns
Attaching the Slides to the Rack
1. Pull the anti-tip foot forward out of the bottom of the rack.
See Figure 8-5 for the anti-tip foot location.
2. Hold a slide in position inside the two left-hand rack columns:
a. The mounting flange on each end must wrap around the outside face of
both the front and rear columns. See Figure 8-5.
b. The two holes in the mounting flange should line up with the two
lowest rack nuts you installed on each column.
c. The extending portion of the slide (slide member) should point forward
out of the rack.