3.
Turn the computer display-side up with the front toward you.
4.
Open the computer as far as possible.
5.
Release the top edge of the keyboard by lifting it up to disengage the keyboard from the tabs on
the top cover
(1)
.
6.
Slide the top edge of the keyboard back
(2)
until it rests against the display.
7.
Release the zero insertion force (ZIF) connector
(1)
to which the keyboard cable is attached and
disconnect the keyboard cable
(2)
from the system board.
8.
Remove the keyboard.
Reverse this procedure to install the keyboard.
Component replacement procedures
57
Содержание COMPAQ PRESARIO G42
