HP Compaq d300 Series, Руководство по эксплуатации

Страница: 27 / 74

HP D300 Digital Dispenser 27
9. After the current set of fluids is dispensed into all appropriate plates, if needed the software will
prompt you to load a new cassette using the message shown in
Figure 4-20 . After a fully used
T8 cassette is removed from the D300 dispenser it may be disposed, as it will not be reused.
10. You will then be shown which fluids to place in each dispensehead of the new cassette as
shown in
Figure 4-22 , and steps 7 - 9 above will continue until the configuration is complete.
4-6 View the report
Depending on the options selected in the Report pane, a report may be automatically generated and
saved on your computer after the plate dispense operation is completed. To change these report
settings, click
Setup , then Options , and then Report (see
―
Options: Report
‖).
If you have chosen not to display the report after each run, you can still view data from the most
recently completed run by clicking
File and then View Report . See Figure 4-27 .
Figure 4-27 Open the Report dialog box by clicking File and then View Report
If you are not sure if a report was automatically saved, look at the title bar of the Report dialog box
(see
Figure 4-28 ). If a file name is displayed in the title bar, then the report was automatically
saved. Even if you did not choose to automatically save the report, you can still save the current
report by clicking the
Save button in the lower-right corner of the Report dialog box.