27
Determining System Problems
Problems with the device
Situation
Possible Reason
Job was not stapled.
(HP 3000-sheet Stapler/
Stacker only)
The job height exceeds the stapling capacity (5 mm).
There is a staple jam.
A single-page job was sent to the Stapler; it will not be
stapled.
The Stapler ran out of staples.
Printer does not
recognize the device or
the user LED on the
device is off.
Check the power cords (see page
29
).
Check the C-link cables (see page
29
).
Make sure that the device has been configured in the
printer driver.
If the printer still does not recognize the device, contact
a dealer or authorized HP service provider. See the user
guide for your specific HP LaserJet printer for service and
support information.
Device does not
power on.
Make sure that the power cord is firmly plugged into both
the device and the power box (see page
29
). Remove and
reconnect the power cord.
Turn the printer off, check all of the C-link connections (see
page
29
), and turn the printer on.
Содержание C4779x
Страница 1: ...Contents HP 3000 sheet Stacker and HP 3000 sheet Stapler Stacker C4779x and C4788x User Guide ...
Страница 7: ...7 User LED Interpretation The following graphic shows the location of the user LED on the device ...
Страница 18: ...18 Clearing Paper Jams The following graphic shows the areas where paper jams might occur ...
Страница 29: ...29 Determining System Problems Cabling Installation Roadmap ...
