Using the HP BladeSystem Insight Display 62
The installation wizard displays the Check: Installation and Cables screen.
8.
Verify all components are installed and connected.
9.
Select
Continue,
and press
OK
to begin checking for configuration and installation errors. When
Continue is selected, the enclosure UID automatically powers off. If
Push Settings = Yes:
o
The enclosure settings are pushed to adjacent enclosures
o
The installation wizards run on each adjacent enclosure
o
The enclosure UID powers off on the adjacent enclosures
If no errors are detected, the rear enclosure UID powers off, and the Insight Display screen illuminates
green.
10.
Press
OK
to return to the Main Menu. Enclosure and blade hardware setup and configuration is
complete.
IMPORTANT:
If errors are detected, the Insight Display screen illuminates amber, and the Health
Summary screen displays. For more information on troubleshooting configuration errors, see
"Insight Display errors (on page
78
)."
All configuration errors prevent the operation of the enclosure and should be corrected
immediately.
11.
Open a browser and connect to the active Onboard Administrator module using the Onboard
Administrator IP address that was configured during the Insight Display installation wizard process.
Содержание BladeSystem c3000
