HP 9840, Руководство по эксплуатации

Страница: 38 / 122

Operating the 9840 Tape Drive
9840 Tape Drive Operations Guide— 429596-002
3- 10
Unloading a Tape Cartridge
•
A “Ready U” (File Unprotected) message mans that tape is loaded and not
write protected.
•
A “Load XXXX” message means that the tape load has failed, where the
“XXXX” is a Fault Symptom Code (see Table A-2, in Appendix A, for
instructions on how to handle this condition).
Unloading a Tape Cartridge
1. Ensure the tape drive is not selected from the host.
2. Press the Unload switch.
3. If the tape fails to eject, see Removing a Stuck Tape Cartridge on page A-6.
If this switch is pressed during a write operation, the drive attempts to write the
remaining data before it unloads. A display of “UnWr XXXX” (Unwritten Data) means
that the attempt failed and some data remains unwritten to tape.
Pressing the Unload switch again causes loss of this data. For the host to save the
unwritten data, issue the following SCSI command before pressing Unload again:
•
Recover Buffer Data
Reclaiming (Reformat) a Tape Cartridge
When a tape cartridge is corrupted or formatted for special uses such as dump or
firmware, it can be reformatted as a data tape and returned to normal usage. This
procedure is referred to as reclaiming a tape for normal use.
1. Take the tape drive offline.
2. Press Menu until the Drive Mode Main Menu is reached. “Drv Menu?” displays.
3. Press Select to enter the Drive Menu.
4. Press Menu until “MakeDataTp” appears.
5. Press Select to initiate; any tape cartridge present in the drive is ejected.
6. When the “Ld Data Tp” displays, place a write-enabled tape in the drive. The
operation starts automatically and erases and reformats any tape.
If “DatCrFailx” is displayed (where x = 1), see Table A-2 in Appendix A for
instructions on how to handle this error condition.
7. When done, exit Drive Mode and remove the tape from the drive.
8. Put the drive online.