HP 9840, Руководство по эксплуатации

Страница: 26 / 122

9840 Operator Panel
9840 Tape Drive Operations Guide— 429596-002
2- 10
Operator Panel Display
IPL Pend IPL Pending is displayed for one
second when IPL is pressed Wait until IPL completes
automatically.
Load CC The common controller code is
loading No action is necessary.
Loading Tape cartridge is being loaded No action is necessary.
Load ESCON Normal display during boot Wait for IPL to complete.
Load (FSC) Load/unload operation has failed Try another tape.
If another tape works, the original
tape is suspect. Refer to
Identifying Unrecoverable Tapes
on page A-3.
If another tape also fails load, reset
the tape drive by performing an
IPL.
If failure persists, contact your
service provider to replace the
tape drive.
Load SCSI Normal display during boot Wait for IPL to complete.
Locating Tape drive is doing a high speed
seek No action is necessary.
Memory Err RAM failed during IPL Reset the tape drive by performing
an IPL again.
If that fails, contact your service
provider to replace tape drive.
NT Ready F Non-write protected tape is in
process of manual unload Wait until unload operation
completes.
NT Ready U Write protected tape is in process
of manual unload Wait until operation completes.
Online The tape drive is operational No action is necessary.
Power Fail Power supply has failed Contact your service provider to
replace the power supply.
Reading The tape drive is in the read mode No action is necessary.
Ready F Loaded tape is file protected Operator discretion.
Ready U Loaded tape is not file protected Operator discretion.
Rewinding The tape drive is rewinding No action is necessary.
Save Fails New configuration cannot be
saved Contact your service provider to
replace tape drive.
SavingDump Displayed while saving dump to
EEPROM Normal display. Wait for the dump
to complete.
Table 2-4. Operator Panel Messages
Display Probable Cause Recommended Action