Technician repair removal and replacement procedures 115
NOTE:
This procedure is specifically for the removal of the Type 1 flow meter.
1.
Power down the MCS unit ("
Powering down the MCS unit
" on page
24
).
2.
Shut off the water flowing into the MCS unit ("
Shutting off the water
" on page
25
).
3.
Remove the bottom fan unit ("
Removing the bottom fan unit
" on page
44
).
4.
Relocate the power inlet box ("
Relocating the power inlet box
" on page
93
).
5.
Remove the condensation pump and sensors ("
Removing the condensation pump and sensors
" on
page
47
).
6.
Remove the bottom heat exchanger unit ("
Removing the heat exchanger unit with couplers
" on page
59
).
7.
Remove the magnetic solenoid valve ("
Removing the magnetic solenoid valve
" on page
82
).
8.
Remove the AC transfer switch ("
Removing the AC transfer switch
" on page
26
).
9.
Using the 46-mm wrench (included in the miscellaneous hardware kit), loosen the two flow meter
union nuts securing the flow meter in place.
WARNING:
To reduce the risk of electric shock or damage to the equipment, use extreme
caution when removing and replacing components that involve water around the electrical
wires and unsecured power inlet box. There is great risk of electrical shock when water is used
near electricity.
WARNING:
To reduce the risk of electric shock or damage to the equipment, be prepared to
clean up the water from the disconnected water line with towels and sponges.
Содержание 403349-003
Страница 13: ...Customer self repair 13 ...
Страница 14: ...Customer self repair 14 ...
Страница 15: ...Customer self repair 15 ...
Страница 16: ...Customer self repair 16 ...
