HP 3C590-TPO, Руководство по установке

Страница: 33 / 44

4 Connecting to a Windows NT Server 4.0
Windows 95 SR2
Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 loaded.
• 3COM Etherlink 3C590 PCI Ethernet card and drivers disk ver. 5.1a.
• Vectra VL8 and VL7 Driver Name: EL59X.VXD Size: 38KB Date: 1/27/97
• Vectra VE7/VE8 Driver Name: Windows 95 Embedded Driver
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization Normal
• Full Duplex Disabled
• Boot PROM Disabled
• Media Type 10BASE-T
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C590 PCI
adapter card into a PCI slot.
2 Connect network cable media to the 3COM 3C590 PCI card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software “Etherlink 3C590 PCI Ethernet
drivers disk Ver. 5.1a” and execute “A:\3C59XCFG.EXE.”
5 Select “Configure NIC”, and verify the resource settings listed above
under the heading “Device Configuration.”
6 If changes are required, save those changes and exit.
7 Remove the 3Com software drivers diskette and reboot the machine.
8 Windows 95 SR2 should automatically recognize the 3COM 3C590
ethernet card.
Vectra VL8 Vectra VL7 Vectra VE7/VE8
I/O Port Address FCC0h (PCI) FDD0h (PCI) DC00h (PCI)
Interrupt Level 10 (PCI) 10 (PCI) 11 (PCI)