HP 3C590-TPO, Руководство по установке

Страница: 10 / 44

2 Connecting to a Netware 4.11 Server
Windows for Workgroups
4 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
If you are using a Vectra VL8, go directly to step 7.
If you are using a VL7 or VE7/VE8, follow the instructions below to
complete the installation.
a Execute INSTALL.EXE.
b Specify the settings as listed below:
• C:\NWCLIENT
• Yes
• Yes
• C:\WINDOWS
• No
• 3Com Fast Etherlink/Etherlink III Bus Master
c Under the heading "Select the driver for your network board", insert
the 3Com 3C590 drivers disk and set the path to "A:\NETWARE\CLI-
ENT." (If you have an HP preloaded HDD, set path to "C:\Masters\Lan-
Drv\3C590\NETWARE\CLIENT\)
d Press "Enter" to continue the installation.
e When prompted, insert the corresponding disks to complete file trans-
fer and driver installation.
f When the install utility is finished, press <CRTL><ALT><DEL> to re-
start the machine.
g After windows loads, open the "NETWORK" folder, double-click the
"NETWORK SETUP" icon.
h Select "Networks" and verify that "Novell Netware (Workstation Shell
4.0 and above)" is selected under "Install Windows support for the fol-
lowing network only:"
i Select "OK" twice, and the installation is complete.
7 Execute INST_DOS.EXE and enter Yes to accept the agreement.