HP 170X - JetDirect Print Server, Руководство по установке и настройке

Страница: 54 / 80

48 CHAPTER 7: HP JETDIRECT CONFIGURATION PAGE MESSAGES
CF ERR - TRAP
LIST EXCEEDED
The TFTP configuration file specified too many
trap destination list entries using the “trap-
destination:” keyword.
CF ERR -
UNKNOWN
KEYWORD
A TFTP configuration file line contained an
unknown keyword.
CONFIGURATION
ERROR
The configuration information for the NetWare
functions is not stored correctly on the
HP JetDirect print server. Rerun the installation
software to reconfigure. If this error persists,
there may be a problem with the HP JetDirect
print server.
CRC ERROR Check the network topology and verify all
cable segments. Check for damaged cables.
DHCP NACK The server has not acknowledged the DHCP
request. Perform a cold reset on the print
server to restart the configuration process.
DISCONNECTED The Novell NetWare protocol is disconnected.
Check the server and the print server.
DISCONNECTING
FROM SERVER
The server has been shut down because of a
configuration change or reset request. This
message automatically clears after a few
seconds, unless the printer is offline, is in an
error state, or is servicing another I/O port or
another network protocol.
Table 7-2 General HP JetDirect Messages
Message
Description
DISCONNECTING
- SPX TIMEOUT
The SPX connection to the print server was lost
after the connection had been made. This
indicates a possible network problem, or a
problem with the print server. Make sure all
cables and routers are functioning correctly.
Try restarting the print server.
ERR
NEGOTIATING
BUFFER SIZE
A failure was detected when selecting the
buffer size to be used when reading print data
from the file server. This may indicate a
network problem.
When the HP JetDirect print server is
configured for multiple file servers, the error is
only displayed on the configuration page if
none of the file servers was successfully
connected.
FAIL RESERVING
PRINTER NUM
The SPX connection to the print server was lost
when the HP JetDirect print server attempted
to reserve the printer number. This indicates a
possible network problem, or a problem with
the print server. Make sure all cables and
routers are functioning correctly. Try restarting
the print server.
FIRMWARE
REVISION:
X.XX.XX
The firmware revision number of the
HP JetDirect print server currently installed in
the printer.
Table 7-2 General HP JetDirect Messages
Message
Description