580 Eastview Drive | Laurel, MS 39443
(p) 601.422.0033 | (f) 601.422.1652 | Toll-Free: 800.956.3456
www.Howard-Lighting.com
Revised 3/6/2016
Need help?
Call 1-800.956.3456 to speak with our installation and product experts.
LED W
ork
L
ight
i
nstaLLation
i
nstructions
LWL-TP-44-120 (
WiTh
T
riPod
)
SAFETY PRECAUTIONS
• Do not open the work light body; no user serviceable parts inside.
• Do not look directly at lighted fixture. Do not remain in bright light if skin feels
warm as you are too close to the fixture.
• Keep fixture away from children.
• Never use around heavy volatile fluids such as gasoline.
• Never operate the fixture with missing glass safety shield.
• This fixture is not intended for use nor safe to use in potentially dangerous locations
such as places with explosive or flammable atmospheres.
• Do not handle this fixture when standing on wet or damp surfaces or in water. To
reduce the risk of electrical shock, this light should always be plugged into properly
grounded 3-wire outlet. If used while exposed to wet or damp surfaces a ground
fault outlet (GFCI) should always be used. Do not remove the ground wire or
grounded plug from the fixture. Always use a U.L. listed 3 wire grounded cord with
electrical capacity to properly handle this light and other tools you might be using.
Never use light around swimming pool, hot tubs or saunas.
• Use only with an extension cord for outdoor use, cord type:
SW,SW-A,SOW,SOW-A,STW,STW-A,STOW,STOW-A,SJW-A,SJOW,SJOW-
A,SJTW,SJTW-A, or SJTOW,SJTOW-A
• When an extension cord is used with this luminaire, the maximimum cord length
shall not exceed 50 feet (15.2 m) from where the cord exits the luminaire to the
receptacle.
assEMBLY instructions
1. Carefully remove the fixture and all the parts from the box. Set out the tripod legs
and loosen the black adjustment knob. Slide center pole through adjustment sleeve
and into bottom pole receiver. Tighten receiver bolt so pole receiver is secure to
pole. Tighten adjustment knob so legs stay fixed in place. If the floor is not flat,
the tripod can be adjusted by loosening the nut on the extension leg. Now you are
ready to install top portion of fixture. (See Figure 1)
2. Adjust the angle of Yoke by T-Knob on sides of work light heads. Position so yoke
is in upright position. Center hole in yoke over hole in crossbar. From underside of
crossbar slide black bolt through hole in yoke. Tighten black knob to secure yoke to
crossbar. Repeat process for second worklight (See Figure 2).
3. Line up hole in center of crossbar over tripod “T” (See figure 3). Screw into top of
pole until snug. Tighten, but do not over tighten.
4. Lamp height can be adjusted by loosening the compression nut, sliding pole to
desired height and retightening the nut (See Figure 4).
1
2
3
4
PARTS LIST
• (1) TP Tripod Assembly
• (2) LWL-22-120 Work Light
• (1) Work Light Stand
• (1) Parts Bag
• (2) 1.25”L ¼-20 Carriage Bolts
• (2) ¼” Flat Washers
• (2) ¼-20 Knobs
• (1) ¼-20 Knob Screw
REqUIREd TOOLS
• Adjustable Wrench
