Getting Started
Fill your Spa
Fill your spa with water using the CleanScreen
®
pre-filter with the valve 50% closed
(45º angle). Once your spa has power and the ACE system is installed, follow these
five simple steps.
NOTE:
If you are not filling your spa for the first time, clean your filters with Filter
Cleaner or replace with new filters, before refilling spa. Soft water or a water softener
can be used to fill the spa, ensure the hardness is a minimum of 25 ppm. If you are
filling with well water or have a known metal issue, see
TREATING FOR METALS
in
the troubleshooting section for additional instructions.
System Start-up
1. Test and balance spa water
using a 5-way test strip. Measure pH, Total
Alkalinity, and Hardness levels, to determine if your water is in the "OK" ranges
specified for the ACE system (see table below) and adjust as needed.
ACE System
Parameter
Target
Min - ”OK” Range - Max
Salt
1750 ppm
1000 ppm
1750 ppm
Hardness
50 ppm
25 ppm
75 ppm
Alkalinity
80 ppm
40 ppm
120 ppm
pH
7.4
7.2
7.6
Chlorine
3 ppm
1 ppm
5 ppm
2. Reduce Hardness to 50 ppm (if Hardness is above 50ppm)
using the
Vanishing Act calcium remover, which may take 24 hours or longer. Rinse the
calcium remover before use, and follow instructions on the box. Continue the
start-up process while the calcium remover is working; be sure to reposition the
bag after jets are turned on/off.
Spa Model
Salt
(cups) or (grams)
Estimated
Increase in ppm
per 1 cup/290g
Gleam
9.5
2750
170 ppm
Pulse
7
2030
210 ppm
Flair
6
1750
250 ppm
Bolt
5.5
1595
275 ppm
Glow
5
1450
310 ppm
3. Add Salt
based on your spa model (see table above) one cup at a time to the
filter compartment with jets running. Run jets for 5 minutes to ensure salt is
ACE Salt Water Sanitizing System
Page 3
Содержание LIMELIGHT COLLECTION Ace
Страница 1: ...L I M E L I G H T C O L L E C T I O N A C E O W N E R S M A N U A L...
Страница 18: ......
Страница 19: ......